How To Install An Electric Tankless Hot Water Heater

Download Article

Download Article

You will thank yourself a 1000000 times over for choosing tankless water heating. Exist aware that at that place will be a slight delay for the hot water to get in at your fixtures and that the money saved in standby loss is offset past the higher cost of equipment, gas pipe, flue pipe and materials.^[one]

Steps Download Article

1. i

   CAUTION: Tankless water heaters generally require larger diameter gas supply lines, higher voltage power supply (if contemplating electric on-demand), dedicated - special stainless steel flue (known every bit Category Ii, III or IV) or larger diameter exhaust system. Please take these things into consideration before you determine to DIY.

2. ii

   Information technology is highly recommended that you lot utilise special union connector sets for the h2o supply which employ featherbed adequacy. This volition allow for uncomplicated, easy de-liming maintenance process in the hereafter.

   Advertisement

3. three

   Plough off main incoming water line to house. ^[2]

4. 4

   Disconnect supply line from old water heater. Y'all will probably have some water left in the line even though your master has been shut off. Place a bucket underneath water bib to catch any spills.

5. 5

   Disconnect heat source from old water heater every bit follows: for gas, (propane) make sure the supply valve is closed (this is commonly determined by the direction of the handle to the valve sitting either in the same direction as the line "open", reverse the direction of the line "closed"). For and electric h2o heater, simply unplug the appliance from the wall outlet.

6. six

   Once yous accept completely disconnected the old water heater you must remove it from it'southward current parking space and make sure to dispose of it according to the laws in the expanse you live in. ^[3]

7. 7

   Remove your new tankless water heater from the carton and place all hardware and instructional textile close at manus.

8. 8

   Make up one's mind the location best suited for this appliance and make sure you have allowed for the proper clearances around it to comply with all state and local building codes.

9. 9

   Mount tankless heater on wall according to manufacturers instructions, making sure that yous take appropriately supported its weight.

10. 10

    Now you're gear up to claw up all the connections.

11. 11

    If you take gas, install ventilation ducting. Typically tankless water heaters requires larger flue or special stainless steel flue.^[4]

12. 12

    Begin with the supply line (h2o line).

13. 13

    Adjacent should be the heat source. If your water heater uses electricity, plug information technology in to the wall.* If your water heater is gas, you will need to hook up a gas supply line from the stub at the wall to the new water heater. Open the valve so that the handle is in the same direction as the line.^[v]

14. fourteen

    Following manufacturers directions, low-cal the airplane pilot on the gas water heater.

15. fifteen

    Now go to your favorite shower location and enjoy an countless stream of hot h2o. All that piece of work was well worth information technology!

    Advertizing

Add together New Question

• Question

  If I have difficult water, practice I need a water softener in order to use a tankless water heater?

  

  If y'all have hard water, I would recommend a whole business firm water softener system regardless of the type of water heater yous have. Hard water volition cause a deposit build up inside the tank of your traditional tank h2o heater, which volition cause problems. It will also crusade deposit build upward in the tankless system. Beyond that, it will cause additional clothing on all of your fixtures.

• Question

  Practise I demand to mount a gas tankless heater upright, or can it be laid on its back?

  

  As with whatever gas appliance, heat rises so the unit of measurement needs to be mounted upright and leveled.

• Question

  Later on I install this, will I have hot water immediately?

  

  In one case installed the unit will provide hot water in accordance with its rated "rising time." Yous will probably notice some lag between opening a hot h2o tap and the h2o from the tap being hot, like to having a tank-style heater. The hot water yet needs to get from the unit to the tap.

• Question

  What exercise I do if I take a recirculating pump?

  

  Tankless hot water heaters are "on demand," and cannot be used for recirculating systems.

• Question

  What size wiring is recommended when installing a tankless hot water heater?

  

  You lot will probably need 220 volt service (as with an electric dryer) with at least 60 amps.

• Question

  If my tankless h2o heater is gas and I have a 1/2 inch gas line to the unit of measurement, will it work for a year and and so have a problem?

  

  Information technology depends on what kind it is. If it is an nether-$200 tank then yep, but if information technology is over that price then no, information technology will be over 2 and 1/ii years until you should beginning noticing any problems.

• Question

  How can I insert batteries in the geyser?

  

  If y'all were to put batteries inside the geyser, they would most likely burn down out because information technology would be and then warm. Plug it into a wall or somewhere instead.

• Question

  Which side, hot or cold, should the expansion be installed?

  

  Install it on the cold water side, between the cold h2o shutoff valve and the water piping line coming in.

• Question

  Can it exist mounted or installed on the outside of a house?

  

  Information technology depends which type of tankless h2o heater you purchase. Do some research and planning before you lot install an outside unit. You will need a unit of measurement that'southward meant to be outside, as well as withstand the weather and temperatures. Keep in mind that outside units require more maintenance, particularly in harsh climates and weather.

• Question

  Where does the hot water pipage connect?

  

  It is connected between the cold water pipe and the hot water pipe. Its heater functions as soon as water flow is detected and continues until the flow stops. Energy and money savings are made, as these tankless units are on simply when used, opposed to older tank units that cycle all the fourth dimension.

Ask a Question

200 characters left

Include your electronic mail address to get a message when this question is answered.

Submit

Advertizing

Video

• Make certain that you have sufficient amps to operate the tankless hot water heater, additionally, it may require three circuits in your circuit box.

• If you purchased an electric hot water heater, brand certain it plugs in to a standard outlet power source. If it is only wired for a different voltage than your mains voltage (mains voltage is usually 100 5 to 240 V depending on your location) so you lot must have an electrician wire that outlet for you (unless you are an electrician yourself).

• Y'all can scrap your old heater for money. Detect a recycling center and take information technology in that location.

• Connect the hot water outlet to the piping as well, or all of your hot water will cease up on the floor.

Thanks for submitting a tip for review!

Advertizing

• Brand sure your h2o pressure is sufficient for a tankless organization

• Be sure to bank check your local plumbing and electric codes prior to starting. Some areas crave a licensed plumber and/or electrician before working on plumbing and electric systems. If in doubt, call your local city building lawmaking enforcement or utility visitor.

• Be sure to read the directions carefully. Some units require the installer be certified to install the unit of measurement in order for the warranty to be valid. Also, some natural gas units require a larger supply and exhaust (read larger piping or larger electric excursion) than a regular tank-blazon water heater, which would require a plumber and/or electrician to install.

• If you use gas as a heat source for this appliance you lot should test your gas connexion past spraying an adequate amount of soapy water on the union and watching for bubbles which would indicate a poor connection and leakage. Turn off the gas immediately and open all windows and doors until consummate ventilation has occurred. Once y'all take cleared the room of leaking gas you lot tin double-check your connection and remedy the trouble. After repairing connection, test again!

Advertisement

Virtually This Commodity

Thanks to all authors for creating a page that has been read 297,198 times.

Did this article help you?

Source: https://www.wikihow.com/Install-a-Tankless-Hot-Water-Heater

Posted by: hieberthisna1950.blogspot.com

Share this post